0086-371-86162511 [email protected]

Spring Cone Crusher

Spring Cone Crusher breaks material by squeezing or compressing it between convex and concave shaped surfaces covered by manganese as the wear surface. Normally used as the secondary or tertiary crusher, the cone crusher has been developed to crush high or medium hardness material, such as iron ore ,copper ore, limestone, quartz, granite, and sand stones, etc. The spring cone crusher has been developed to crush feed materials into desired end products efficiently, reliably and economically.This series offers the highest crushing efficiency and end product quality with the lowest cost per tone production. The safety system uses dry oil and water as two kinds of sealed formation to make plaster powder and engine oil separate to make sure reliable performance. The type of crushing chamber depends upon size of feeding and fineness of crushed product. The standard type (PYB) is applied to medium crushing, the medium type is applied to medium or fine crushing and the short head type is applied to fine crushing.

PERFORMANCE

Cone crusher crushes materials by the working surface between the movable cone and fixed cone. So it is more advanced and efficiency efficient than jaw crusher. The movable cone is supported by spherical bearing and fixed on an hanging erect shaft which is set in the eccentric sleeve, and the sleeve is set on the stopping and pushing bearing. The movable cone and erect shaft are driven by the eccentric shaft sleeve together. The eccentric shaft sleeve is driven by horizontal shaft and fimbriated gear, and the wheel of the conveyor belt is driven by motor through v-belts. The lower part of vertical shaft is installed in the eccentric sleeve. When the eccentric sleeve rotates, there is a conical surface lined out by the shaft. When the movable cone comes near the fixed cone, rocks are grinded into pieces, when the movable cone leaves, grinded materials is discharged from the discharge hole. The fixed cone can be ascended or descended by adjusting setting to adjust the width of discharge hole, consequently the output size is determined adjusted.

SPECIFICATIONS

SOLUTIONS

  • 10 t/h line grinding steel slag in Ukraine
    Materials: Steel slag
    Yields:
    10TPH
    More...

  • 6TPH limestone grinding line in Vietnam
    Materials: Limestone
    Yields:
    6TPH
    More...

  • Pebble crusher for road building
    Materials: pebble
    Yields:
    70-100TPH
    More...

  • 5 t/h line grinding limestone in Mexico
    Materials: Limestone
    Yields:
    5 TPH
    More...

CONTACT US

Get price and support, find the working site in your country !

Other details :
Name:* Email:*
other contacts:
Equipment: Aplication:

RECOMMENDED PRODUCTS

  • JC Series
    Jaw Crusher
    Output Size:
    10mm to 275mm
    More...

  • HPT cone
    crusher
    Output Size:
    >  6mm
    More...

  • HC hydraulic
    cone crusher
    Output Size:
    various size
    More...

CONTACT US

Tel:0086-371-86162511(24 hours)
Fax:0086-371-67998980
Email:[email protected]